• PSA200.jpg
  • 6.具备多种测量接口.jpg
  • 5(1709724225352).png
  • 4(1709724225343).png
  • 3(1709724225330).png


PSA200 uses a 10.1-inch LED backlight high brightness display, supporting multi-touch operation, with spectrum analysis, network measurement, strong field measurement, channel scanning, third-order interoperability, harmonic distortion, noise loading, Pass-Fail and so on. Smart measurement function. Highly integrated radio frequency front -end and full digital intermediate frequency technology ensure its excellent performance and stable performance. The real -time bandwidth of the maximum 40MHz meets the test of common radio signals such as mobile communication, television and WIFI. The built -in GPS/BD and electronic compass function modules are suitable use.

Key words:

The PSA series spectrum analyzer is a broadband, high-performance portable microwave spectrum analyzer that measures frequencies ranging from 5kHz to 20GHz, and can be used both indoors and outdoors.

The product adopts a 10.1-inch LED backlight high brightness display screen, supporting multi-point touch operation, and has various intelligent measurement functions such as spectrum analysis, network measurement, field strength measurement, channel scanning, third-order intermodulation, harmonic distortion, carrier to noise ratio, and Pass - Fail. Highly integrated RF front-end and fully digital IF technology ensure excellent performance and stable performance, with a maximum real-time bandwidth of 40MHz to meet the testing of commonly used radio signals such as mobile communication, television, and WiFi. The built-in GPS/BD function module is suitable for outdoor use. The product is widely used in various fields such as aerospace, microwave communication, satellite navigation, radar detection, electronic detection and countermeasures, precision guidance, etc.

Universal spectrum analysis function

The general spectrum analysis complete parameters such as the frequency and power of the signal through the two measurement methods of scanning and FFT.

Advanced measurement function

With the measurement functions such as strong measurement, frequency counting, channel measurement, third-order interoperability, harmonic distortion, noise ratio, chromatography, audio demodulation, and PASS-FAIL.

Excellent ability to distinguish bandwidth

Can be distinguished by a very close -up signal.

Express the average noise level

Ensure the ability to measure faint signals.

Support touch screen can quickly complete operations

10.1 -inch high bright touch screen and support touch operation.

Have a variety of measurement interfaces

There are interfaces such as mid -frequency output, external reference input, external trigger input, USB, LAN, headset and other interfaces.
  • Frequency range: 9kHz~20GHz
  • Maximum real-time bandwidth: 40MHz
  • Resolution bandwidth: 1Hz~5MHz
  • Phase noise: -90dBc/ Hz@10kHz
  • Display average noise level: -160dBm
  • Scanning time non zero scanning width: 5ms to 3000s
  • Scan time zero scan width: 20us to 3000s
  • Scanning mode: continuous, single shot
  • Trigger source: free, video, external
  • Overall power consumption: approximately 29W
Model Name Frequency range Maximum real-time bandwidth Resolution Bandwidth Phase noise Display average noise level Trace Source Price
PSA080 5kHz~8GHz 40MHz 1Hz~5MHz -98dBc/Hz@10kHz -160dBm Optional Quote
PSA180 9kHz~18GHz 40MHz 1Hz~5MHz -90dBc/Hz@10kHz -160dBm Optional Quote
PSA200 9kHz~20GHz 40MHz 1Hz~5MHz -90dBc/Hz@10kHz -160dBm Optional Quote
PSA260 9kHz~26.5GHz 40MHz 1Hz~5MHz -90dBc/Hz@10kHz -160dBm Optional Quote
Configuration Designation Model
spectrometer host 5kHz to 8GHz PSA080
9kHz to 20GHz PSA200
state CD-ROM (user manual, programming manual)  
AC/DC adapter (AC input,+20V output)  
Optional Advanced options PSA-AWK
High -stable basis options PSA-OCX0
GPS/BD Navigation PSA-BD
Near -field probe kit Ant01
omnidirectional antenna/directional antenna 0A750/DA800
USB power sensor UP60

Previous Page

Next Page

Previous Page

Next Page

Universal attachments (optional)

Vector Net Calibration Kit

Sagittal Net Calibration Kit (4 SAM type negative calibration pieces, DC-9GHz)

Ultra short wave handheld direction finding antenna (9kHz~8000MHz)

9KHz-30MHz handheld directional antenna 20MHz~200MHz handheld directional antenna 200MHz~500MHz handheld directional antenna 500MHz~8000MHz handheld directional antenna

LNA010 broadband amplifier

When not using a direct power cord, it is necessary to ensure that the input voltage of the broadband amplifier is+5V. When using a direct power cord, it is necessary to ensure that the input voltage of the direct power cord is+5V

PLA030 Pulse limiter

The main function of a limiter is to limit the output signal amplitude to a certain range, which means that when the input amplitude exceeds a certain reference value, the output amplitude will be limited to a certain amplitude and will no longer change with the input voltage. The applicable frequency range is 50kHz~1GHz.

RFS003 Radio frequency switch

The applicable frequency range of the RF switch (RFS003) is 9kHz~300MHz. When the RF switch is turned off, the isolation degree is 34dB (minimum value). This RF switch is mainly used in conjunction with our company's limiter.

ANT01 Near-field probe

ANT01 is a cost-effective near-field probe primarily used to locate interference sources and determine the cause of interference. It can be used to detect the direction and strength of the magnetic field on the surface of the device;

PRBI-400 Current injection probe

The current injection probe is mainly used for conducting sensitivity measurement; The interference signal is injected into the signal cable or power line of EUT to simulate external interference to determine the conduction sensitivity of EUT.

CDN016-M3 Coupling decoupling network

The coupling/decoupling  network consists of two parts: coupling and decoupling.The main  function of decoupling is to prevent useful signals from leaking to the power supply terminal (AE port) and to prevent disturbing signals from interfering with useful signals. The function of coupling is to transmit the disturbance signal of the device under test (EUT port) to the signal port.(RF port) in order to measure by measuring instruments, or transmit the electromagnetic disturbance signal of RF transmitter to the tested equipment. 

VB30 vswr bridge

• Frequencyrange: 10MHz-3.6GHz  • Tested port: N (female) type  • IN-1o-DUTinsertion loss: 4dB (typical)  • Directionality: 24dB (typical)  • Maximum input power: +30dBm(lW)  • Applicable models: HSA800 series, SAi 000 series and SA2000 series 

T/R1000 RF Demo Kit

• Radio frequency amplifier: The frequency range is 10MHz~2GHz,And the gain is 9dB~15d8(14dB@lGHz) • Radio frequency band-pass filter: Bandwidth 920MHz沉5MHz,Center frequency 922.5MHz  • Mixer: RF IN 5MHz~1500MHz             LO IN 5MHz~500MHz             RF OUT DC-1000MHz  • Oscillator LO/N:Frequency range 35MHz~4400MHz, Output power -3dBm--10dBm  •Oscillator LO:The frequency range is 2200MHz~4400MHz.,And the output power is 0dBm~+ 13dBm • Variable gain amplifier:Frequency range 15MHz~30MHz, gainrange 0dB~30dB  • Intermediate band pass filter: Bandwidth19.9MHz~22.9MHz ,Center frequency 21.4MHz • Reference timebase: 10MHz  •Interfuce:USB

FD100 frequency detection characteristic test module

• Based on BALUELEC Spectrum Analyzer, It can provide frequency discrimination   characteristic test function, Which can replace frequency scrumer  • Size 100mmx60mmx25mm • Universal USB interfuce for easy control  • Weight≤200g • Applicable models: SA1000 series and SA2000 series

DA800 directional broadband antenna

• Frequency measurement range: 600MHz-8000MHz •Input impedance: 50Ω • VSWR(Typical):<2:1 • Gain (Typical): 6dBi • Weight: 400g • Dimension: 353mrnx223mrnx28mrn

Message feedback

Welcome to leave a message online, please fill in the information according to the following form; We will contact you as soon as possible according to the information you fill in

Submit Message

Contact Us

Tel: +86-0551-68107097

Email: admin@baluelec.com

Address: No. 800, Wangjiang West Road, High-tech Zone, Hefei City, Anhui Province China.

Video Number
Video Number

Copyright © Baluelec


 Powered by: 300.cn  |  SEO   |   Business License